Public Protocol
Platform

Element 13.13

Storage, power and cooling for small computers

Sheet
13.13
Chapter
13 Digital infrastructure
State
Drafted
Release
16 November 2026
Editor
Contributed by Praecise as open research
Reviewers
To be named at review
Safety
S2, as the chapter
Licence
CC BY-SA 4.0
Resources
14

The element

Requirement

Each small computer has storage that suits its write load, a supply that holds the stated voltage through the day and the night, and cooling that keeps it out of throttling in the hottest hour of its site. No single power cut destroys its data.

How to tell

The supply meets the maker's figure at the plug: Raspberry Pi 5 asks for 5 V at 5 A (27 W), and a 3 A supply limits USB peripherals to 600 mA (Getting started with your Raspberry Pi). The board's temperature, read under the heaviest real load, stays below the throttling band: Raspberry Pi boards throttle the cores progressively from 80 degrees and throttle cores and GPU at 85 (Raspberry Pi hardware documentation). The storage matches the write load: the K3s documentation states that the write-heavy etcd datastore is more than SD cards and eMMC can handle and recommends an SSD (K3s requirements). A power cut is pulled on purpose and the machine comes back with its data (13.5).

Options

Storage.

An SSD is not immune to power loss: in a 2013 study, 13 of 15 commodity SSDs failed under injected power faults, with bit corruption, metadata corruption and total failure among the faults (Understanding the Robustness of SSDs under Power Fault). Steady power and backups matter whatever the medium.

Power. Measured peak draw during language model work was 8 W on Raspberry Pi 4, 10 W on Raspberry Pi 5 and 14 W on Orange Pi 5 Pro (An Evaluation of LLMs Inference on Popular Single-board Computers). Raspberry Pi states that edge AI devices typically work within a single-digit watt budget (When and why you might need the Raspberry Pi AI HAT+ 2). Off-grid supply, charge control and batteries are domain 5 work: the IEC TS 62257 series covers off-grid renewable systems (IEC TS 62257-100:2022 Renewable energy off-grid systems - Part 100: Overview of the IEC 62257 series), and Libre Solar publishes open charge controller and battery management designs (Libre Solar). Battery fires and mains wiring can kill: follow those standards and a qualified installer; this element gives no procedure.

Cooling. Raspberry Pi states that throttling protects the chip, so a heatsink is not needed to prevent damage, but a heatsink or fan reduces throttling (Raspberry Pi hardware documentation). The Pi 5 fan runs from 50 degrees and reaches full speed at 75 (Raspberry Pi hardware documentation); the AI HAT+ documentation recommends the Active Cooler and a heatsink for heavy AI work (AI HAT+ and AI HAT+ 2 (Raspberry Pi documentation)). The Pi 5 brief asks for a well-ventilated place and an uncovered case (Raspberry Pi 5 Product Brief).

Settled, open, contested

Settled. Voltage at the plug, throttling temperatures and the SSD advice for write-heavy loads are stated by the makers (Getting started with your Raspberry Pi, Raspberry Pi hardware documentation, K3s requirements). Open. No primary, measured source was found on microSD wear or on card corruption at power loss in small computers; the advice in circulation is mostly anecdote. Contested. Card against SSD for simple jobs: a card is cheaper and simpler; an SSD is faster and suits writes, but is not proof against power faults (Understanding the Robustness of SSDs under Power Fault).

The four stages

Learn: throttling and the maker's power figures (Raspberry Pi hardware documentation, Getting started with your Raspberry Pi). Design: write the write load and choose card, eMMC or SSD (K3s requirements, Raspberry Pi SSD); size the energy from measured draw (An Evaluation of LLMs Inference on Popular Single-board Computers) with domain 5. Build: maker's supply, short cable, cooler (AI HAT+ and AI HAT+ 2 (Raspberry Pi documentation)). Deploy: log temperature and throttling, test a pulled plug, back up (13.5).

Resources at each stage

What changes between 30 adults and 300 people

At 30 adults one board on a good supply and an SSD, with a nightly backup. At 300 people boards on shared DC supplies or PoE, temperature alerts, spare storage pre-imaged, and the computing load entered in the energy budget (domain 5).

Reference designs

  • Reference design

    Libre Solar

    Open designs for charge controllers and battery management systems, with a learning resource on how such systems work.

    External resource. Not made or verified by Public ProtocolMaturity: Not assessedSafety S2Listed 16 November 2026

Parts list

Every resource that supports this element. Those marked External carry the label “External resource. Not made or verified by Public Protocol”.

ResourceTypeOriginMaturitySafetyLicence, as stated at its source
IEC TS 62257-100:2022 Renewable energy off-grid systems - Part 100: Overview of the IEC 62257 seriesStandardExternalEstablishedS2Not stated on the page opened
K3s requirementsDatasheetExternalEstablishedS1Not stated on the page opened
Libre SolarReference designExternalNot assessedS2BMS firmware: Apache-2.0, as stated in its repository
An Evaluation of LLMs Inference on Popular Single-board ComputersPaperExternalPrototypeS0arXiv non-exclusive distribution licence 1.0
Raspberry Pi 5 Product BriefDatasheetExternalEstablishedS1Not stated on the page opened
When and why you might need the Raspberry Pi AI HAT+ 2GuideExternalWorkingS0Not stated on the page opened
AI HAT+ and AI HAT+ 2 (Raspberry Pi documentation)GuideExternalEstablishedS0Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0); some content from the eLinux wiki under CC BY-SA 3.0 Unported
Compute Modules (Raspberry Pi documentation)DatasheetExternalEstablishedS1Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0); some content from the eLinux wiki under CC BY-SA 3.0 Unported
Raspberry Pi hardware documentationDatasheetExternalEstablishedS1Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0); some content from the eLinux wiki under CC BY-SA 3.0 Unported
Getting started with your Raspberry PiGuideExternalEstablishedS1Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0); some content from the eLinux wiki under CC BY-SA 3.0 Unported
Raspberry Pi SD CardsDatasheetExternalEstablishedS0Not stated on the page opened
Raspberry Pi SSDDatasheetExternalEstablishedS0Not stated on the page opened
Application Performance Class (SD Association)StandardExternalEstablishedS0Not stated on the page opened
Understanding the Robustness of SSDs under Power FaultPaperExternalReplicatedS0Not stated on the page opened; USENIX states that its proceedings are free to everyone (open access)

Depends on, and completes

Depends on 13.1, 13.5.

It is one of 25 elements that complete Digital infrastructure.

The standing questions

Who can afford this: an SSD and cooler add to each board's cost. Who does the work: the keeper, with an electrician for any off-grid or mains work. Who decides: how much of the energy budget goes to computing is a community decision (15.2).

Environments

Safety

State and evidence

Drafted

An editor has written the element's text from the resources listed under it, citing them. It is checked when it is reviewed.

Evidence from a real place or system is recorded here, with what did not work. What the states mean

History