Element 3.12
Storage, distribution, hot water and water safety plans
- Sheet
- 3.12
- Chapter
- 3 Water
- State
- Drafted
- Release
- 16 November 2026
- Editor
- Contributed by Praecise as open research
- Reviewers
- To be named at review
- Safety
- S3, as the chapter
- Licence
- CC BY-SA 4.0
- Resources
- 10
The element
- Requirement
Water stays safe from the treatment point to every tap and shower: tanks are covered and cleaned, the network is kept under pressure and checked for leaks, materials in contact with water are approved, and hot-water systems are run at temperatures that control Legionella. All of it sits inside one written water safety plan. Drinking water and hot-water systems are at safety level S3; hot-water heaters and pressure vessels are installed by a qualified person to national code.
- How to tell
- A water safety plan covers source, treatment, storage, distribution and buildings (Water safety plan manual: step-by-step risk management for drinking-water suppliers. Second edition, Water safety in distribution systems, Water safety in buildings).
- Hot water: WHO states that Legionella grows at 20 to 50 °C, and that hot water should be kept above 50 °C with water leaving the heater at or above 60 °C, cold water below 25 °C and ideally below 20 °C, and unused taps flushed weekly (Legionellosis (WHO fact sheet)).
- Residual: chlorine residual 0.2 to 0.5 mg/l at collection points, tested at the near and far ends of the network (Measuring chlorine levels in water supplies (WHO Technical Note 11)).
- Leakage is measured. The EU directive requires leakage assessment, with an EU threshold to be set by January 2028 and national action plans by January 2030 (Drinking water (European Commission page on Directive (EU) 2020/2184)). WHO's worked demand example adds 10 per cent for leakage (How much water is needed in emergencies (WHO Technical Note 9)).
- Materials: in the EU, hygiene rules for materials in contact with drinking water apply from December 2026 (Drinking water (European Commission page on Directive (EU) 2020/2184)).
- Options
- Tanks and cisterns: covered, dark, screened, cleaned on a schedule (SSWM Toolbox); cistern materials are discussed in the rainwater manual (The Texas Manual on Rainwater Harvesting (third edition)).
- Gravity networks from a tank or spring; pumped networks where the site is flat.
- Network modelling before buying pipe, with EPANET (EPANET).
- Hot water: central or point-of-use heating, each run at the WHO temperatures above (Legionellosis (WHO fact sheet)); where temperature control is not feasible, WHO points to treating the system with a suitable biocide (Legionellosis (WHO fact sheet)).
- Building plans: shared buildings such as schools and clinics have their own building water plan (Water safety in buildings).
- Settled, open, contested
Settled: continuous pressure, residual at the far ends, hot water hot and cold water cold (Legionellosis (WHO fact sheet), Measuring chlorine levels in water supplies (WHO Technical Note 11)). Open: the EU leakage threshold is not yet set (Drinking water (European Commission page on Directive (EU) 2020/2184)). Contested: running hot water at 60 °C costs energy and raises scalding risk; WHO's fact sheet sets the temperature for Legionella control, and how to balance this against energy saving is argued by practitioners. No open source weighing the two was opened in this work.
The four stages
Learn: how quality is lost after treatment (Water safety in distribution systems, Water safety in buildings). Design: model the network (EPANET), place tanks and heaters, choose approved materials (Drinking water (European Commission page on Directive (EU) 2020/2184)). Build: to national plumbing code, with qualified installers for heaters. Deploy: test residual and temperatures, repair leaks, clean tanks, review the plan yearly (Water safety plan manual: step-by-step risk management for drinking-water suppliers. Second edition).
Resources at each stage
1 Learn
Understand
- Drinking water (European Commission page on Directive (EU) 2020/2184) Standard, S3
- SSWM Toolbox Guide, S2
- The Texas Manual on Rainwater Harvesting (third edition) Guide, S3
- Legionellosis (WHO fact sheet) Guide, S3
- Measuring chlorine levels in water supplies (WHO Technical Note 11) Guide, S3
- How much water is needed in emergencies (WHO Technical Note 9) Guide, S3
2 Design
Size and choose
- EPANET Tool, S0
- Drinking water (European Commission page on Directive (EU) 2020/2184) Standard, S3
- SSWM Toolbox Guide, S2
- The Texas Manual on Rainwater Harvesting (third edition) Guide, S3
- Legionellosis (WHO fact sheet) Guide, S3
- How much water is needed in emergencies (WHO Technical Note 9) Guide, S3
- Water safety in buildings Guide, S3
- Water safety in distribution systems Guide, S3
- Water safety plan manual: step-by-step risk management for drinking-water suppliers. Second edition Guide, S3
4 Deploy
Install, run and measure
- Drinking water (European Commission page on Directive (EU) 2020/2184) Standard, S3
- Legionellosis (WHO fact sheet) Guide, S3
- Measuring chlorine levels in water supplies (WHO Technical Note 11) Guide, S3
- Water safety in buildings Guide, S3
- Water safety in distribution systems Guide, S3
- Water safety plan manual: step-by-step risk management for drinking-water suppliers. Second edition Guide, S3
What changes between 30 adults and 300 people
At 30 adults, a few tanks, a short network and household heaters, checked by one trained member. At 300, a modelled network with isolating valves and meters for leak detection, a building water plan for each shared building, and temperature logging on central hot-water systems (Water safety in buildings).
Reference designs
Open for contributions Designs with drawings, specifications and a bill of materials. Add to it
Parts list
Every resource that supports this element. Those marked External carry the label “External resource. Not made or verified by Public Protocol”.
| Resource | Type | Origin | Maturity | Safety | Licence, as stated at its source |
|---|---|---|---|---|---|
| EPANET | Tool | External | Established | S0 | Public domain software that can be freely copied and distributed |
| Drinking water (European Commission page on Directive (EU) 2020/2184) | Standard | External | Established | S3 | Not stated on the page opened |
| SSWM Toolbox | Guide | External | Not assessed | S2 | Not stated on the page opened; a page on using SSWM content is linked |
| The Texas Manual on Rainwater Harvesting (third edition) | Guide | External | Established | S3 | Not stated on the page opened |
| Legionellosis (WHO fact sheet) | Guide | External | Established | S3 | Not stated on the page opened |
| Measuring chlorine levels in water supplies (WHO Technical Note 11) | Guide | External | Established | S3 | © World Health Organization 2013. All rights reserved |
| How much water is needed in emergencies (WHO Technical Note 9) | Guide | External | Established | S3 | © World Health Organization 2013. All rights reserved |
| Water safety in buildings | Guide | External | Established | S3 | World Health Organization - All rights reserved |
| Water safety in distribution systems | Guide | External | Established | S3 | Not stated on the page opened |
| Water safety plan manual: step-by-step risk management for drinking-water suppliers. Second edition | Guide | External | Established | S3 | CC BY-NC-SA 3.0 IGO |
The standing questions
Who can afford this: pipes, meters and heaters. Who does the work: a maintenance rota with a qualified plumber on call. Who decides: the group sets service levels; the operator can shut a section to repair it.
Environments
no source found.
chlorine contact must be longer below 18 °C (Measuring chlorine levels in water supplies (WHO Technical Note 11)); no source found on freeze protection of pipes or permafrost.
cold water should stay below 25 °C (Legionellosis (WHO fact sheet)); in heat this is harder, but no source with methods was opened.
same temperature rule applies (Legionellosis (WHO fact sheet)).
no source found.
no source found.
no source found.
Environment profiles for these settings: Small islands and coasts; Arctic, subarctic and permafrost, including sea ice; Extreme cold; Hot deserts; Extreme heat; Tropical rainforest and humid tropics; High humidity; Temperate and boreal forests; Mountains and high altitude; River deltas and flood plains. All environments
Safety
State and evidence
Drafted
An editor has written the element's text from the resources listed under it, citing them. It is checked when it is reviewed.
Evidence from a real place or system is recorded here, with what did not work. What the states mean
History
- Drafted in the release of 16 November 2026.